The MINI BUFFS small design and screw adapters allow the professional or beginner to work with either an orbital (D/A-dual action) buffer/sander or any standard drill accepting a 1/4" shank.

Because the WIZARDS MINI BUFFS encompass a small 3" to 4" area, they are ideal for tight areas and spot repairs on paint blemishes and defects, without affecting the surrounding area. This can eliminate the need for unnecessary buffing and swirl mark removal in body shop applications.

CONTENTS: 3" x 1" 100% Tufted Wool Cutting Pad, 4" x 1.25" Orange Foam Light Cutting Pad, 4" x 1.25" Blue Foam Finishing Pad, 3" x 3/4" Hook & Loop Backing Plate, 1 D/A Adapter, 1 Drill Adapter.

DIRECTIONS: Because of differences in tools (D/A or drill) and differences in paint conditions, results may vary. Adjust the techniques suggested below to fit your situation. When using a drill, avoid fast back and forth movements and always avoid riding edges. Be sure to inspect often as you buff. Always apply compounds, polishes and sealers to cool surfaces, concentrating on one small area at a time.

1) If sanding is required to level out blemishes or defects, always finish sand first with 2000 grit or finer paper, then begin buffing with the WOOL MINI BUFF (cutting) using TURBO CUT compound (for deeper scratches) or FINISH CUT compound (for lighter scratches). Holding pad flat to the surface, apply pressure as needed to achieve desired results. After buffing, remove residue with WIPE DOWN Inspection Detailer using a MULTI-FIBER cloth and inspect surface.

2) Use the ORANGE FOAM MINI BUFF (light cutting) with either FINISH CUT or SCRATCH REMOVER. Remove residue with WIPE DOWN using a MULTI-FIBER cloth and inspect surface.

3) Use the BLUE FOAM MINI BUFF (final finishing) with SHINE MASTER for fresher paint and SUPREME SEAL for cured paint.

HINT: Spur pads as needed and wash them with hot soapy water. Let air dry.

If sealing protection on a small, cured paint surface is all that is needed, first smooth and prepare the surface using CLAY MATE with WIPE DOWN Inspection Detailer. Wipe clean with a MULTI FIBER cloth. Then apply SUPREME SEAL, using the BLUE FOAM MINI BUFF.